Filter
Top Products
10
Specifying the speaker
parameters
Use the remote for the operation.
1 From your listening position, press
SPEAKER LEVEL.
Adjustable menus and parameters are
described below.
2 Press v or V repeatedly to select the
parameter.
3 Press b or B repeatedly to select the
setting you want.
4 Repeat steps 2 to 3 to set other
parameters.
5 Press ENTER.
Tip
You can use the digipad instead of the cursor buttons
(v/V/b/B).
Adjustable parameters
The default settings are in the parentheses.
xBALANCE
• FRNT L___R: (center)
Balance between the front left and right
speakers.
• (MHC-DP800AV only)
REAR L___R: (center)
Balance between the rear left and right
speakers.
Range: 6 dB (L) to 6 dB (R), 13 steps
xLEVEL (MHC-DP800AV only)
• REAR
**
dB: (0 dB)
Level of the rear speakers.
Range: –6 dB to 6 dB, 1 dB steps
• CTR
**
dB: (0 dB)
Level of the center speaker.
Range: –6 dB to 6 dB, 1 dB steps
• SW
**
dB: (10 dB)
Level of the sub woofer.
Range: –10 dB to 10 dB, 1 dB steps
xLFE
• LFE
*****
: (0 dB)
Level of the LFE (Low Frequency Effect)
channel output.
Range: OFF, –20 dB to 0 dB, 1 dB steps
“OFF” cuts the sound of the LFE channel.
However, the low frequency sound of the
speakers are output from the sub woofer.
“–20 dB” to “0 dB” settings allow you to
attenuate the LFE signal. “0 dB” outputs the
full LFE signal at the mix level determined by
the recording engineer.
xD.COMP.
• D.COMP.: (STD)
Dynamic range compression.
Range: OFF, 0.1 to 0.9, STD, MAX
“OFF” does not compress the dynamic range.
“0.1” to “0.9” settings allow you to compress
the dynamic range in small steps. “STD”
reproduces the sound track with the dynamic
range intended by the recording engineer.
“MAX” provides a great compression of the
dynamic range.
x T.TONE (MHC-DP800AV only)
• T.TONE: (OFF)
Test tone output.
Range: OFF, ON
“ON” outputs the test tone from each speaker in
sequence. Adjust the LEVEL and BALANCE
parameters so that the volume level of the test
tone from each speaker sounds the same using
the remote from your listening position. Select
“OFF” to turn off the test tone.
Notes
• When you adjust the level of the sub woofer, set
T.TONE to “OFF”.
• Dynamic range compression is possible with Dolby
Digital sources only.