Filter
Top Products
31
Other Functions
Using the rotary
commander
The rotary commander works by pressing
buttons and/or rotating controls.
You can also control the optional CD or MD
units with the rotary commander.
By pressing buttons (the SOURCE
and MODE buttons)
Each time you press (SOURCE), the
source changes as follows:
TUNER t CD t MD
Pressing (MODE) changes the operation
in the following ways;
• Tuner : FM1 t FM2 t MW t LW
• CD unit : CD1 t CD2 t …
• MD unit : MD1 t MD2 t …
(SOURCE)
(MODE)
1 Press (SOUND) for two seconds.
2 Press (SOUND) repeatedly until “SUB”
appears.
3 Press (5) (t).
4 Rotate the dial to select the desired cut-
off frequency.
The cut-off frequency in the display
changes as follows:
62 Hz
y
78 Hz
y
99 Hz
y
125 Hz
y
157 Hz
y
off
If you want to adjust the volume of the
subwoofer(s), press (2) (T) and rotate the
dial as in step 3 of “Adjusting the volume of
the subwoofer(s).”
5 Press (SOUND) for two seconds.
After the frequency setting is complete, the
display returns to the normal playback
mode.
Listening to each program
source in its registered
DSO
— Source Sound Memory (SSM)
Each time you return to the same source, you
can hear the same DSO menu and equalizer
curve registered for that source, even after
changing the program source or turning the
unit off and then on again.