Filter
Top Products
Editing Recorded MDs
34
EN
3 Turn AMS until “Nm In ?” appears in the display,
then press AMS.
4 Turn AMS to select “Disc” to label an MD, or to
specify the track to label, and press AMS.
A flashing cursor appears in the display.
5 Press DISPLAY/CHAR to select the character
type as follows:
To select Press DISPLAY/CHAR repeatedly
until
Uppercase letters “A” appears in the display
Lowercase letters “a” appears in the display
Numbers “0” appears in the display
A
6 Turn AMS to select the character.
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
! ” # $ % & ’ ( ) * + , – . / : ; < = > ? @ _ `
D
You can press DISPLAY/CHAR to change the
character type at any time during Step 6 (see
Step 5).
7 Press AMS to enter the selected character.
The cursor shifts rightward and waits for the input
of the next character.
D
8 Repeat Steps 6 and 7 until you have entered the
entire title.
If you entered the wrong character
Press 0 or ) until the character to be corrected
starts flashing, and repeat Steps 6 and 7 to enter
the correct character.
To erase a character
Press 0 or ) until the character to be erased
starts flashing, then press EDIT/NO.
To enter a space
Press AMS or ) while the cursor is flashing.
9 Press YES.
This completes the labeling procedure and the title
appears in the display.
To cancel labeling
Press p.
Note
You cannot label a track or an MD while you are recording
over an existing track.
Copying a track or disc title
You can copy a track or disc title to use it as a title of
another track or the disc title within a disc. Note that
you can do this operation by using the controls on the
deck only.
1 Press EDIT/NO.
2 Turn AMS until “Name ?” appears in the display
and press AMS.
3 Turn AMS until “Nm Copy ?” appears in the
display.
4 Press AMS.
5 Turn AMS to select “Disc” to copy the disc title, or
the track whose title you want to copy and press
AMS.
If “No Name” appears in the display
The disc or the track has no name.
6 Turn AMS to select “Disc” for disc title or to
specify the track number to copy a title, and press
AMS.
“Complete!!” appears for a few seconds to indicate
that the copying operation is completed.
To cancel title copying
Press EDIT/NO or p.