Filter
Top Products
18
EN
Additional Information
Specifications
Amplifier section
Video section
Inputs
Outputs
General
System
Power
requirements
Power
consumption
AC outlets
Dimensions
Mass (Approx.)
Supplied
accessories
VIDEO 1, 2, 3, TV/LD
VIDEO IN:
1 Vp-p 75 ohms
VIDEO 1, 3 S VIDEO:
Y: 1 Vp-p, unbalanced,
sync negative
C: 0.286 Vp-p,
load impedance
75 ohms
VIDEO 1, 2, MONITOR
VIDEO OUT:
1 Vp-p 75 ohms
VIDEO 1, MONITOR
S VIDEO:
Y: 1 Vp-p, unbalanced,
sync negative
C: 0.286 Vp-p,
load impedance
75 ohms
Preamplifier section: Low-
noise NF type equalizer
Power amplifier section:
Pure-complimentary SEPP
220-230 V AC, 50/60 Hz
230 W
1 switched, total 100 W
430 x 157 x 355 mm
(17 x 6
1
/4 x 14 inches)
10.5 kg (23 lb 3 oz)
Remote commander
(remote) (1)
Size AA (R6) batteries (2)
POWER OUTPUT
Stereo mode
Surround mode
Frequency
response
(DIN 1 kHz, 4 ohms)
90 W + 90 W
(DIN 1 kHz, 4 ohms)
Front:
90 W/ch
Centre:
90 W
(only in the PRO
LOGIC mode)
Rear:
25 W
PHONO: RIAA
equalization curve
±0.5 dB
TUNER, CD, TAPE/MD,
VIDEO 1, 2, 3, TV/LD:
10 Hz - 50 kHz dB
+0
–1
Impedance
50
kilohms
50
kilohms
S/N
(weighting
network,
input level)
75 dB**
(A, 2.5 mV)
82 dB**
(A, 150 mV)
Sensitivity
2.5 mV
200 mV
150 mV
PHONO
(MM)
CD
TAPE/
MD,
TUNER,
VIDEO 1,
2, 3, TV/
LD
Inputs
** ‘78 IHF
Outputs
Muting
BASS BOOST
TONE
TAPE/MD REC OUT,
VIDEO 1, 2 AUDIO
OUT: Voltage 150 mV,
Impedance 10 kilohms
MIX AUDIO OUT
Voltage: 2 V
Impedance: 1 kilohms
PHONES: Accepts low
and high impedance
headphones
– 20 dB
+10 dB at 70 Hz
±8 dB at 100 Hz and
10 kHz
Glossary
Centre mode
Setting of speakers to enhance Dolby Pro
Logic Surround mode. To obtain the best
possible surround sound, select one of the
following four centre modes according to
your speaker system.
• NORMAL mode
Select NORMAL mode if you have front
and rear speakers and a small centre
speaker. Since a small speaker cannot
produce enough bass, the bass sound of
the centre channel is output from the front
speakers.
• WIDE mode
Select WIDE mode if you have front and
rear speakers and a large centre speaker.
With the WIDE mode, you can take full
advantage of Dolby Surround sound.
• PHANTOM mode
Select PHANTOM mode if you have front
and rear speakers but no centre speaker.
The sound of the centre channel is output
from the front speakers.
Centre
speaker
Rear
speaker (R)
Rear
speaker (L)
Front
speaker (R)
Front
speaker (L)
Centre
speaker
Rear
speaker (R)
Rear
speaker (L)
Front
speaker (R)
Front
speaker (L)
Front
speaker (L)
Front
speaker (R)
Rear
speaker (R)
Rear
speaker (L)
Design and specifications are subject to
change without notice.