Filter
Top Products
24
US
4 Press to start the
measurement.
Measurement starts in 5 seconds.
While the time is counting down, stand
away from the measurement area to avoid
measurement error.
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
Note
If “CHK MIC” appears, you cannot perform the
Auto Calibration. Connect the calibration mic, then
restart the Auto Calibration.
Tips
• When Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
– Press ?/1 or MUTING.
– Press input buttons on the remote or INPUT
SELECTOR on the receiver.
– Change the volume level.
1 Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
2 Press V/v repeatedly to select
the item. Then, press .
Note
After “SAVE” is displayed for 50 seconds, the
measurement result is saved automatically,
without the need to save the procedure.
3 Save the measurement result.
Select “SAVE” in step 2.
The measurement results are saved.
Measurement for Display
Speaker existance TONE
Speaker gain, distance,
frequency response
T.S.P.
Subwoofer gain and distance WOOFER
Confirming/saving the
measurement results
Measurement
result
Display Explanation
When the
measurement
process
completes
properly
SAVE Proceed to step
2.
When the
measurement
process fails
ERROR
XXXX
See “When
error codes
appear” (page
25).
Item Explanation
SAVE Saves the measurement
results and exits the setting
process.
WRN CHK Displays warning
concerning the
measurement results. See
“When you select “WRN
CHK”” (page 25).
DIST Displays the measurement
result for speaker distance.
LEVEL Displays the measurement
result for speaker level.
EXIT Exits the setting process
without saving the
measurement results.