Filter
Top Products
4
US
This equipment must not be co-located
or operated in conjunction with any other
antenna or transmitter.
This equipment complies with FCC
radiation exposure limits set forth for an
uncontrolled environment and meets the
FCC radio frequency (RF) Exposure
Guidelines in Supplement C to OET65.
This equipment has very low levels of RF
energy that it deemed to comply without
maximum permissive exposure
evaluation (MPE). But it is desirable that it
should be installed and operated
keeping the radiator at least 20 cm or
more away from person’s body
(excluding extremities: hands, wrists,
feet and ankles).
For the customers in the Canada
Properly shielded and grounded cables
and connectors must be used for
connection to host computers and/or
peripherals.
This device complies with Industry
Canada licence-exempt RSS standard(s).
Operation is subject to the following two
conditions:
(1) this device may not cause
interference, and (2) this device must
accept any interference, including
interference that may cause undesired
operation of the device.
This equipment complies with IC
radiation exposure limits set forth for an
uncontrolled environment and meets
RSS-102 of the IC radio frequency (RF)
Exposure rules.
This equipment has very low levels of RF
energy that it deemed to comply without
maximum permissive exposure
evaluation (MPE). But it is desirable that it
should be installed and operated
keeping the radiator at least 20 cm or
more away from person’s body
(excluding extremities: hands, wrists,
feet and ankles).
Precautions
On safety
Should any solid object or liquid fall into
the system, unplug the system and
have it checked by qualified personnel
before operating it any further.
Do not climb on the Sound Bar or the
subwoofer, as you may fall down and
injure yourself, or system damage may
result.
On power sources
Before operating the system, check that
the operating voltage is identical to
your local power supply. The operating
voltage is indicated on the nameplate
at the rear of the Sound Bar.
If you are not going to use the system
for a long time, be sure to disconnect
the system from the wall outlet (mains).
To disconnect the AC power cord
(mains lead), grasp the plug itself; never
pull the cord.
One blade of the plug is wider than the
other for the purpose of safety and will
fit into the wall outlet (mains) only one
way. If you are unable to insert the plug
fully into the outlet, contact your dealer.
AC power cord (mains lead) must be
changed only at the qualified service
shop.
On heat buildup
Although the system heats up during
operation, this is not a malfunction. If you
continuously use this system at a large
volume, the system temperature of the
back and bottom rises considerably. To
avoid burning yourself, do not touch the
system.