Filter
Top Products
36
US
direct command from the remote control and
the command via the Sound Bar.
• If the Sound Bar is placed where it does not
obstruct the remote control sensor of the TV,
be sure to set IR REP. to “OFF”.
• On some TVs, this function does not work.
In this case, move the Sound Bar to another
location.
The current firmware version
information appears on the front panel
display.
You can specify the wireless connection
to be used to link the Sound Bar to the
subwoofer using the Secure Link
function.
This function is useful when you use
multiple wireless products.
1 Press AMP MENU.
2 Select “WS” in the AMP menu,
then press or c.
3 Select “S. ON,” then press or
c.
4 “START” appears, then press
.
“SEARCH” appears, and the Sound
Bar searches for equipment that can
be used with Secure Link.
Proceed to the next step within 2
minutes.
To quit the Secure Link function
during a search for equipment, press
C.
5 Press SECURE LINK on the rear
of the subwoofer with the point
of a pen, etc.
The ?/1 indicator on the subwoofer
lights in amber. “SUCCEED”
appears on the front panel display.
If “FAILED” appears on the front
panel display, check to ensure the
subwoofer is turned on, and try to
perform the process again from
step 1.
6 Press AMP MENU.
The AMP menu turns off.
1 Press AMP MENU.
2 Select “WS” in the AMP menu,
then press or c.
3 Select “S. OFF,” then press
or c.
4 “RELEASE” appears, then press
.
“FINISH” appears on the front panel
display.
5 Press AMP MENU.
The AMP menu turns off.
Checking the version of
the Sound Bar
(VERSION)
Activating wireless
transmission between
specific units (S. ON)
Cancelling the Secure
Link function (S. OFF)