Filter
Top Products
2
GB
English
WARNING
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer servicing to
qualified personnel only.
Do not install the appliance in a confined space, such as a bookcase
or built-in cabinet.
Laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.
This appliance is classified as a
CLASS 1 LASER product.
The CLASS 1 LASER PRODUCT
MARKING is located on the rear
exterior.
This caution
label is located
inside the unit.
NOTICE FOR THE CUSTOMERS IN THE
UNITED KINGDOM
— For the tuner CD player —
A moulded plug complying with BS 1363 is fitted to this equipment
for your safety and convenience.
Should the fuse in the plug supplied need to be replaced, a 5 AMP
fuse approved by ASTA or BSI to BS 1362, (i.e. marked with 2 or @
mark) must be used.
If the plug supplied with this equipment has a detachable fuse
cover, be sure to attach the fuse cover after you change the fuse.
Never use the plug without the fuse cover. If you should lose the
fuse cover, please contact your nearest Sony service station.
IMPORTANT
If the plug supplied is not suitable for the socket outlets in your home, it
should be cut off and an appropriate plug fitted in accordance with the
following instructions.
The wires in this mains lead are coloured in accordance with the
following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
Do not connect either wire to the earth terminal in the plug which is
marked by the letter E or by the safety earth symbol Y or coloured
green or green-and-yellow.
WARNING
To prevent shock hazard, do not insert the plug cut off from the mains
lead into a socket outlet. This plug cannot be used and should be
destroyed.
— For the active speaker system —
The mains lead plug of SA-N1/N11 is a 2-pin type designed to be
connected only to HCD-T1.
Do not connect this plug to any other system or mains supply.
IMPORTANT
Never connect two mains leads into a single mains plug.