Filter
Top Products
DR-BT21iK [US, ES] 3-280-325-52(1)
US US
DR-BT21iK [US, ES] 3-280-325-52(1)
27
US US
Re-pairing the transmitter and the headset
1
Turn on the power of iPod.
(Make sure the iPod is in pause mode.)
2
Connect the transmitter to the iPod (page 16).
3
Place the transmitter and the headset to be paired together
within 1 m (3 ft).
4
Press and hold the POWER button of the headset for about 7
seconds or more to enter “Pairing in process” while the headset is
turned o.
Aer about 3 seconds, the headset indicator (red) and the
headset indicator (blue) will ash twice, but keep pressing the
POWER button.
Release the POWER button when the headset indicator starts
ashing quickly. e headset enters the pairing process.
5
Press and hold the power button of the transmitter for about 7
seconds or more to enter “Pairing in process.”
Aer about 1 second, the transmitter indicator will ash twice,
but keep pressing the power button.
Notes
When rst power on the transmitter aer initialized, the transmitter will enter
“Pairing in process” automatically.
e pairing information is initialized if you press and hold the power button for 15
seconds. e transmitter indicator lights up for 5 seconds before the initialization
starts. Release the button immediately when the transmitter indicator lights up.
“Pairing in process” is released aer about 5 minutes. If pairing is not established
within about 5 minutes, repeat the above procedure from step
4
. iPod backlight may
turn on in this 5 minutes.
To enter “Pairing in process,” you need to turn o the power of the transmitter rst.