Filter
Top Products
Getting Started
21
GB
A To connect to a TV with the SCART input jack
Connect the system to your TV using the SCART (EURO AV) cord (not supplied).
Be sure to connect the SCART (EURO AV) cord to the EURO AV T OUTPUT (TO TV) jack on the
system.
When you connect using the SCART (EURO AV) cord, check that the TV conforms to VIDEO signal
or RGB signals. If the TV conforms to VIDEO signal, change the input mode of the TV to RGB signals.
Refer to the operating instructions supplied with the TV to be connected.
B To connect to a TV with the VIDEO IN jacks
Connect the video cord.
C To connect to a TV with the S VIDEO IN jack
Connect an S video cord (not supplied). When using the S video jack instead of the video jacks, your
TV monitor must also be connected via an S video jack. S video signals are on a separate bus from the
video signals and will not be output through the video jacks.
D To connect to a TV with the COMPONENT VIDEO IN jacks
Connect a component video cord (not supplied). To use the COMPONENT VIDEO OUT jacks (Y, PB/
C
B, PR/CR) instead of the video jacks, your TV monitor must be equipped with via COMPONENT
VIDEO IN jacks (Y, P
B/CB, PR/CR). If your TV accepts progressive format signals, you should use this
connection and set the output channel of the system to progressive format (page 22).
• Only when DVD function is selected (by pressing FUNCTION repeatedly until “DVD” appears in the front panel
display), the COMPONENT VIDEO OUT jacks output video signals.
When connecting to a standard 4:3 screen TV
Depending on the disc, the image may not fit your TV screen.
To change the aspect ratio, see page 81.
Note
Yellow
Green
Blue
Red
continued