Filter
Top Products
26
GB
You can use the speakers by installing on the
wall.
Depending on the status of IR transmission (for
wireless system), you can install the IR
transmitter on the wall.
Installing the speakers on a
wall
1 Prepare screws (not supplied) that are
suitable for the hole on the back of
each speaker. See the illustrations
below.
2 Fasten the screws to the wall.
For the center speaker
For the other speakers
3 Hang the speakers on the screws.
Note
• Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a beam and fasten them
to the wall. Install the speakers on a vertical and flat
wall where reinforcement is applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
Installing the Speakers
and the IR transmitter on a
Wall
30 mm (1
3
/
16
inches)
4 mm (
5
/
32
inch)
Hole on the back of
the speaker
4.6 mm
(
3
/
16
inch)
10 mm
(
13
/
32
inch)
6 to 9 mm
(
1
/
4
to
3
/
8
inch
)
265 mm
(10
7
/
16
inches)
6 to 9 mm
(
1
/
4
to
3
/
8
inch
)
170 mm
(
6
23
/
32
inches
)
4.6 mm
(
3
/
16
inch)
10 mm
(
13
/
32
inch)
Rear of speaker