Filter
Top Products
Tape – Recording/Sound Adjustment
15
GB
You can record just the portions you like from a
CD, tape or radio program on a tape. You can
also record from connected components (see
“Recording audio from a connected component”
on page 25).
1 Load a recordable tape into deck B.
2 Press FUNCTION or TUNER/BAND
repeatedly to select the desired source
to record.
3 Press z REC.
Deck B stands by for recording.
When you want to record on the reverse
side, press h.
4 Press DIRECTION repeatedly to select
g to record on one side. Select j
(or RELAY) to record on both sides.
5 Press X, then start playing the desired
source to record.
Recording starts.
To stop recording
Press x.
Note
You cannot listen to other sources while recording.
Tips
• When you record on both sides, be sure to start from
the front side. If you start from the reverse side,
recording stops at the end of the reverse side.
• For recording from the tape:
If you set the direction to
j (or RELAY) when the
tapes you use have different lengths, the tapes in each
deck reverses independently.
• For recording from the radio:
If noise is heard while recording from the radio,
move the respective antenna to reduce the noise.
You can reinforce the bass and create a more
powerful sound.
Press X-GROOVE.
Each time you press the button, the display
changes as follows:
X-GROOVE ON (on)
Y
X-GROOVE OFF (off)
Tip
Factory set to “X-GROOVE ON”.
Recording on a tape
manually
— Manual Recording
Sound Adjustment
Adjusting the sound
continued