Filter
Top Products
Recording/Editing
25
X
H
x
DECK A/DECK B
INPUT
REC z
OPEN/CLOSE
REC z
INPUT
X
x
H
With the label side up
3 After “New Track” appears in the
display, press H on DECK B to start
recording.
Synchro-Recording starts. DECK A and
DECK B will automatically stop after
recording.
To stop recording
Press x.
To record only your favorite CD
tracks
You can record only your favorite CD tracks
using Program Play. Between steps 1 and 2,
perform steps 1 to 4 of “Creating Your own
Program (Program Play)” (page 19).
Note
When Program Play is selected, you cannot perform
Make-Disc Synchro-Recording.
To record from several discs
(RCD-W500C only)
In step 1, set the play mode to “ALL DISCS”
or “PGM” and program the discs you want to
record, then proceed to step 2.
Notes
• When the play mode is set to “ALL DISCS”, the
recording starts from the disc whose indicator lights
in green. Then the following discs are recorded.
(After Disc 5, Disc 1 is selected).
• If you select “ALL DISCS” even though you want
to record only one disc, discs you did not intend to
record may be recorded.
Recording on a CD-R or
CD-RW Manually
You can start recording from the end of the
existing material. Before recording, see page
20.
When using the remote, set DECK A/DECK B
to DECK B.
• After recording, you must finalize the disc.
Until the disc is properly finalized, it cannot
be played on any CD players. See
“Finalizing a CD-R or CD-RW” on page 29.
1 Turn on the amplifier and the sound
source, and then select the sound
source on the amplifier.
2 Press OPEN/CLOSE of DECK B and
place a recordable CD-R or CD-RW on
DECK B.
Press OPEN/CLOSE again to close the
disc tray.
continued