Filter
Top Products
12
GB
You can make a program of up to 25 steps.
You can synchro record the programed tracks
onto a cassette tape (page 18).
1 Press CD (or FUNCTION repeatedly) to
switch the function to CD.
2 Press PLAY MODE repeatedly in stop
mode until “PGM” appears.
3 Press . or > repeatedly until the
desired track number appears.
When programing the MP3 audio tracks,
press + or – to select
album, then press
. or > repeatedly until the desired
track number appears.
4 Press ENTER.
The track is programed.
The program step number appears,
followed by the last programed track
number and the total playing time.
5 To program additional tracks, repeat
steps 3 and 4.
6 Press N (or CD/NX on the unit).
Program Play starts.
Other operations
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press N
(or CD/NX on the unit). However, the program is
cleared when you open the CD compartment.
• “– –.– –” appears when the total CD program time
exceeds 100 minutes, or when you select a CD track
whose number is 21 or over, or when you select an
MP3 audio track.
Creating your own
program
— Program Play
Total playing time
(including selected track)
Selected track
number
To Do this
Cancel Program Play Press PLAY MODE
repeatedly in stop mode
until “PGM” disappears.
Erase the program Press CLEAR in stop
mode.
Each time you press the
button, a track is cleared
from the end of the
program.
Add a track to the end of
the program
Perform steps 3 and 4 in
stop mode.