Filter
Top Products
7
Getting Started
Step 3: Presetting radio
stations
— Preset
The system can store a total of 30 preset stations
(20 for FM and 10 for AM). This section explains
how to tune in stations and preset them.
7
5
2
6
3
4
1
1 Press FUNCTION repeatedly until
“TUNER” appears.
2 Press TUNER/BAND to select FM or
AM.
3 Press TUNING MODE repeatedly until
“AUTO” appears.
4 Press j/J.
The frequency changes as the system scans
for a station. Scanning stops automatically
when a station is tuned in. At that time,
“TUNED” and “STEREO” (for stereo
programs only) appear.
FM1005
AUTO
STEREO
TUNED
M
H
z
5 Press MEMORY.
A preset number flashes.
1FM1005
STEREO
TUNED
M
H
z
PRESET
6 Press l/L repeatedly to select
the preset number that you want.
3FM1005
STEREO
TUNED
M
H
z
PRESET
7 Press ENTER.
The station is stored to the selected preset
number.
8 Repeat steps 2 through 7 to preset other
stations.
To tune in a weak station
In step 3, press TUNING MODE repeatedly until
“AUTO” and “PRESET” disappear, then press
j/J repeatedly to tune in the station.
To change the preset number
Start over from step 2.
Tip
The preset stations are saved in the system’s memory
for about a day even if you disconnect the power cord
or a power failure occurs.
To change the AM tuning
interval (not applicable on the
European and Middle Eastern
models)
The AM tuning interval is factory-preset to 9 kHz (or
10 kHz on North American model). To switch the
AM tuning interval, tune in any AM station first, then
turn off the system. Pressing TUNER + on the unit
down, turn the system back on. When you change the
interval, all the AM preset stations are erased. To
change back to the original interval, repeat the same
procedure for CMT-CP2W. For CMT-CP2WA, tune
in any AM station first, then turn off the system.
Pressing TUNER – down, turn the system back on.