Filter
Top Products
Additional information46
GB
Exchanging the SW STATION CALL ROM
To purchase the newest ROM, refer to ”Purchasing the latest SW
STATION CALL ROM” and contact F Corporation.
2 Remove the ROM compartment
lid and the ROM in the
compartment. Be careful not to
touch the contact surfaces
(metallic parts).
3 Insert the projection of the ROM
in the compartment cavity and
place the replacement ROM in
the ROM compartment with the
contact surface facing down.
Be careful not to touch the
contact surfaces.
4 Insert the projections of the
ROM compartment lid in the
compartment cavities and lock
the cover by sliding RELEASE
opposite the direction of the
arrow while holding down the
lid.
1 Hold down the ROM
compartment lid at the bottom of
the unit and slide RELEASE in
the direction of the arrow. Then,
release your finger slowly from
the lid.
Note
Do not touch the contact surfaces on the ROM or the radio, as this may
cause a malfunction.
Cleaning the SW STATION CALL ROM contact surface
If ”NO” ”ROM” is displayed with the SW STATION CALL ROM
inserted in the ROM compartment, the contact surface of the ROM may
be dirty.
Remove the ROM following the steps above and clean the contact surface
with a cotton swab.
Note
Do not clean the contact springs of the main unit, as they may deform
and cause a malfunction.
Cavity
Cavities