Filter
Top Products
Listening to the radio28
GB
ABC
1
DEF
2
GHI
3
JKL
4
MNO
5
PQR
6
STU
7
MY DW VOA BBC OTH
VWX
8
YZ
9
<>
/
FM/
AM
ON/
OFF
POWER
0
ab
DISPLAY
AM BAND
LABEL EDIT
TIME SET
HOLD
LOCAL/
WORLD
TIMERSTANDBY/
STANDBY TIME SET
STANDBY MEMORY
TIME SET
TIME DIFF
SW STATION CALL
JOG/
TUNE/
SCAN˚
DIRECT
ENTER
DST
ERASE
SLEEP
LIGHT
SYNC
SSB
EXE
POWER
ON/OFF
MY
Tuning in to a MY-Memory station
1 Press POWER ON/OFF to turn on the radio.
2 Press MY.
The radio enters the MY-Memory tuning mode.
3 Press MY again.
The radio scans the frequencies stored in MY-Memory and stops at
reception.
Press the button again to resume scanning.
To stop scanning
Press MY during scan.
To manually recall the MY-Memory frequencies one by one
Hold down MY and press ¿ , ÷ or
–
1¿ , ÷1
+.
The frequency changes quickly when
–
1¿ or ÷1
+
is held down
and stops when released.
Tips
• MY-Memory scans only the stored memory numbers and skips the
empty ones.
• MY-Memory scans fastest if the frequencies are stored in ascending or
descending order.
• If MY is pressed with no frequency stored in MY-Memory, a beep
sounds and ”MEMORY” ”EMPTY” appears in the display. Then the
display returns to the previous condition.
• When scanning at night when reception is intense, or when scanning
under prevalent interference, the unit may stop scanning to null
broadcasts frequently. Switch ATT to ON and adjust sensitivity with
the ATT Control (see ”Controlling scan stops”, page 21). Under normal
conditions, set ATT to OFF.
When there is no reception
If any of the frequencies stored in MY-Memory was not received,
scanning stops with a beep when the radio returns to the
frequency where it started scanning.
Lowest stored
MY-Memory number
Scan start
MY-Memory number
Highest stored
MY-Memory number