Filter
Top Products
The following checks will assist in the correction of most problems which you may encounter with your unit.
Should any problem persist after you have made these checks, consult your nearest Sony service facility.
Before going through the check list below, first refer back to the connection and operating procedures.
Trouble
No audio from one or both channels
Play does not begin.
Discs cannot be played continuously.
Remote commander does not operate
the unit.
CaUSO$
Incorrect operation of the amplifier
Loose connection
No disc in the disc compartment
The player is in the pause mode.
Moisture condensation
The disc is set upside down.
The disc is tilted.
The disc is extremely dirty.
Play did not start from the disc in the
DISC 1 tray.
The batteries are exhausted.
The remote commander is not pointed
at the remote control sensor.
There is an obstacle between the
remote commander and the unit.
The remote commander is too far from
the unit.
Remedy
Operate correctly.
Connect the cords firmly.
Put disc(s) in the compartment.
Press Ib II (or II on the remote
commander) to release pause.
Leave the player turned on for about an
hour.
Set the disc with the label side up.
Set the disc correctly.
Clean the disc.
Press DISC SELECT 1 to start play.
Replace both batteries.
Point the remote commander to the
sensor.
Remove the obstacle.
Move closer.
Any operation is not possible. The internal control program may not Turn OFF the power and turn it ON
run. again.