Filter
Top Products
58
US
Troubleshooting
If you experience any of the following difficulties while using the system, use this troubleshooting
guide to help remedy the problem before requesting repairs. Should any problem persist, consult your
nearest Sony dealer.
Note that if service personnel changes some parts during repair, these parts may be retained.
Power
General
Picture
Symptom Problems and solutions
The power is not turned on. • Check that the AC power cord (mains lead) is connected securely.
“PROTECTOR” and “PUSH
POWER” appear alternately in
the front panel display.
Press "/1 to turn off the system, and check the following items after
“STANDBY” disappears.
• Are the + and – speaker cords short-circuited?
• Are you using only the specified speakers?
• Is anything blocking the ventilation holes of the system?
• After checking the above items and fixing any problems, turn on the system. If
the cause of the problem cannot be found even after checking all the above
items, consult your nearest Sony dealer.
Symptom Problems and solutions
The remote does not function. • The distance between the remote and the unit is too far.
• The batteries in the remote are weak.
• When you cannot perform menu operations via the front panel display, press
HOME on the remote.
The system does not work
normally.
• Disconnect the AC power cord (mains lead) from the wall outlet (mains), then
reconnect after several minutes.
Symptom Problems and solutions
There is no picture. • Check the video connection (page 21).
• The unit is not connected to the correct TV input jack (page 21).
• The video input on the TV is not set so that you can view pictures from the
system.
• Check the output method on your system (page 21).
• The unit is connected to an input device that is not HDCP (High-bandwidth
Digital Content Protection) compliant (“HDMI” on the front panel does not
light up) (page 21).
• When playing a double-layer DVD, the video and audio may be momentarily
interrupted at the point where the layers switch.
3D images do not appear on the
TV screen.
• Depending on the TV or video component, 3D images may not appear.
No picture appears when the
video output resolution selected
in [Output Video Format] is
incorrect.
• Press and hold N and VOL – on the unit for more than 5 seconds to reset the
video output resolution to the lowest resolution.