Filter
Top Products
Additional Information
69
GB
Picture
Symptom Problems and solutions
There is no picture. • Check the output method on your system (page 22).
There is no picture when you
make an HDMI cable
connection.
• The unit is connected to an input device that is not HDCP (High-bandwidth
Digital Content Protection) compliant (“HDMI” on the front panel does not
light up) (page 22).
3D images from the HDMI (IN
1) or HDMI (IN 2) jack do not
appear on the TV screen.
• Depending on the TV or video component, 3D images may not appear.
There is no picture or output
resolution is low when you make
a component video cable
connection. (Non-European/
non-Saudi Arabian models
only.)
• When playing a BD-ROM, a high-resolution image may not be output because
of copy protection limitations. We recommend to make a HDMI connection
(page 22).
No picture appears when the
video output resolution selected
in [Output Video Format] is
incorrect.
• Press and hold N and VOL – on the unit for more than 5 seconds to reset the
video output resolution to the lowest resolution.
The dark area of the picture is too
dark/the bright area is too bright
or unnatural.
• Set [Picture Quality Mode] to [Standard] (default) (page 40).
The picture is not output
correctly.
• Check the [Output Video Format] settings in [Screen Settings] (page 61).
• If the analog and digital signals are output at the same time, set [BD/DVD-
ROM 1080/24p Output] in [Screen Settings] to [Off] (page 61).
• For BD-ROMs, check the [BD/DVD-ROM 1080/24p Output] settings in
[Screen Settings] (page 61).
Picture noise appears. •Clean the disc.
• If the picture output from your system goes through your VCR to get to your
TV, the copy-protection signal applied to some BD/DVD programs could affect
picture quality. If you still experience problems even when you connect your
unit directly to your TV, try connecting your unit to the other input jacks.
An image is not displayed on the
entire TV screen.
• Check the setting of [TV Type] in [Screen Settings](page 60).
• The aspect ratio on the disc is fixed.
Color irregularity occurs on the
TV screen.
• If the speakers are used with a CRT-based TV or projector, install the speakers
at least 0.3 meters from the TV set.
• If the color irregularity persists, turn off the TV set once, then turn it on after 15
to 30 minutes.
• Make sure that no magnetic object (magnetic latch on a TV stand, health care
device, toy, etc.) is placed near the speakers.
There is no picture after playing
a video/photo file on the iPod/
iPhone.
• Select the input on your TV for this system.