Filter
Top Products
35
GB
Getting Started
Note
• The ECM-AC2 jack is used for the supplied
calibration microphone only. Do not connect
other microphones.
10Press C/c to select [YES].
Note
• Make sure that the headphones are not
connected to the surround amplifier (page 74).
You cannot operate following steps with the
headphones connected.
• Before [AUTO CALIBRATION], be sure that
the surround amplifier turns on and you install
the surround amplifier in the appropriate
location. If you install the surround amplifier in
an improper location, such as another room,
proper measurement will not be obtained.
11 Press .
[AUTO CALIBRATION] starts. Be quiet
during the measurement.
Note
• Loud test sound is output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
and neighbours.
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 1 minute), as it may interfere with
measurement.
12 Unplug the calibration microphone and
press C/c to select [YES].
Note
• The environment of the room in which the
system is installed may affect measurements.
• If measurement fails, follow the message then
retry [AUTO CALIBRATION].
13 Press .
Quick Setup is finished. All connections
and setup operations are complete.
To quit the Quick Setup
Press DISPLAY in any Step.
Ti
p
• If you cancel [AUTO CALIBRATION], perform the
speaker settings in “Settings for the Speakers”
(page 96).
• If you change the position of the speakers, reset the
speaker settings. See “Calibrating the Appropriate
Settings Automatically” (page 88).
• If you want to change any of the settings, see “Using
the Setup Display” (page 90).
• For details on [AUTO CALIBRATION] and the error
messages of [AUTO CALIBRATION], see
“Calibrating the Appropriate Settings Automatically”
(page 88).
DMPORT
Calibration microphone
Rear of the control unit
To ECM-AC2 jack
cont
i
nue
d