Filter
Top Products
32
GB
Getting Started
To use the wireless system, you need to set up
the surround amplifier. Before setting, make
sure that the wireless transmitter and transceiver
are inserted into the subwoofer and the surround
amplifier correctly (page 25).
This wireless system is called “S-AIR”.
For details of the S-AIR function, see “Using an
S-AIR Product” (page 74).
The subwoofer transmits sound to the surround
amplifier that is connected to the surround
speakers. To establish sound transmission,
perform the following steps.
1 Press "/1 on the control unit.
The system turns on.
2 Make sure that the SURROUND
SELECTOR switch of the surround
amplifier is set to SURROUND.
3 Set the S-AIR ID switch of the surround
amplifier to A.
4 Press POWER on the surround
amplifier.
The POWER / ON LINE indicator turns
green. If not, check the transmission status
as follows.
To check the transmission status
You can check the status of sound transmission
between the subwoofer and surround amplifier
by checking the POWER / ON LINE indicator
of the surround amplifier.
To enjoy the sound by using
headphones
You can enjoy the system’s sound in a place
apart from the control unit by connecting the
headphones to the PHONES jack on the
surround amplifier.
Note
• When you connect headphones to the surround
amplifier, neither the control unit nor the surround
amplifier outputs sound from the system’s speakers.
• The volume of the system may become minimize if
you turn off the surround amplifier while the
headphones are connected to the surround amplifier,
or radio reception is poor. In this case,
“HP NO LINK” and “VOLUME MIN” appear
alternately in the front panel display. Check radio
reception, and set the volume again.
When you use the multiple S-AIR
product
You can prevent miss transmission between the
S-AIR products by setting a different ID for each
S-AIR product. For details, see “Establishing
sound transmission between the S-AIR main
unit and S-AIR sub unit (ID setting)” (page 75).
Step 3: Setting up the
Wireless System
"/1
POWER
POWER/ON LINE
PHONES
R
SURROUND SELECTOR
S-AIR ID
EZW-RT
10
SPEAKER
SURROUND
PAI RI N G
C
B
A
SURROUND
BACK
L
POWER
POWER / ON LINE
Indicator
SURROUND
SELECTOR switch
S-AIR ID switch
PHONES jack
POWER / ON LINE
indicator
Status
Turns green. Sound transmission is
established.
Flashes green. Sound transmission is not
established.
For details, see “Surround
amplifier operation”
(page 109).
Turns red. The surround amplifier does
not output sound.
For details, see “Surround
amplifier operation”
(page 109).
Turns off. The surround amplifier turns
off or its protection is active.
For details, see “Surround
amplifier operation”
(page 109).