Filter
Top Products
98
GB
AM tuner section
Tuning range
Antenna (aerial) Loop antenna
Intermediate frequency
450 kHz
5)
You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
the receiver. While holding down TUNING
MODE, press POWER on the receiver. All preset
stations will be erased when you change the tuning
scale. To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure.
Video section
Inputs/Outputs
Video: 1 Vp-p, 75 ohms
COMPONENT VIDEO:
Y: 1 Vp-p, 75 ohms
P
B/CB: 0.7 Vp-p, 75 ohms
P
R/CR: 0.7 Vp-p, 75 ohms
80 MHz HD Pass Through
General
Power requirements
Power output (DIGITAL MEDIA PORT)
DC OUT: 5V, 0.7 A MAX
Power consumption
Power consumption (during standby mode)
0.7 W
(When “CTRL:HDMI” in
HDMI menu is set to
“CTRL OFF”)
Dimensions (width/height/depth) (Approx.)
430 × 157.5 × 318 mm
including projecting parts
and controls
Mass (Approx.) 8.4 kg
Supplied accessories
Operating instructions (this manual)
Quick Setup Guide (1)
FM wire antenna (aerial) (1)
AM loop antenna (aerial) (1)
Remote commander (RM-AAP022) (1)
R6 (size-AA) batteries (2)
Optimizer microphone (ECM-AC2) (1)
Design and specifications are subject to
change without notice.
Area code Tuning scale
10 kHz step 9 kHz step
CEL, CEK, ECE – 531 kHz –
1,602 kHz
AU, E51 530 kHz –
1,710 kHz
5)
531 kHz –
1,710 kHz
5)
Area code Power requirements
CEL, CEK, ECE 230 V AC, 50/60 Hz
AU 240 V AC, 50 Hz
E51 120/220/240 V AC, 50/60 Hz
Area code Power consumption
CEL, CEK, ECE,
AU, E51
230 W
For details on the area code of the
component you are using, see page 3.