Sony 3-289-450-44(1) Stereo Receiver User Manual


 
33
GB
Getting Started
Press AUTO CAL.
Measurement starts in 5 seconds. A count
down is displayed.
The measurement process will take
approximately 30 seconds to complete.
The table below shows the display when
measurement starts.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• The measurements may not be performed correctly
or Auto Calibration cannot be performed when
special speakers, such as dipole speakers are used.
To cancel Auto Calibration
The Auto Calibration function will be
canceled when you do the following during the
measurement process:
–Press ?/1 or POWER on the receiver.
Press the input buttons or turn the INPUT
SELECTOR on the receiver.
Change the volume level.
Press MUTING.
Change the setting of the SPEAKERS (OFF/
A/B/A+B).
Connect headphones.
–Press AUTO CAL again.
1 Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
2 Press AMP and then press V/v
repeatedly to select the item.
Then, press .
Measurement for Display
Speaker existence TONE
Speaker gain, distance, frequency
response
T.S.P.
Subwoofer gain and distance WOOFER
Confirming/saving the
measurement results
Measurement
result
Display Explanation
When the
measurement
process
completes
properly
SAVE EXIT
Proceed to step
2.
When the
measurement
process fails
E -
xxx
:
xx
See “Message
list after Auto
Calibration
measurement”
(page 35).
Item Explanation
EXIT Exits the setting process
without saving the
measurement results.
LEVEL INFO. Displays the measurement
result for speaker level.
DIST. INFO. Displays the measurement
result for speaker distance.
PHASE INFO. Displays the phase of each
speaker (in phase/out of
phase). See “When you
select “PHASE INFO.””
(page 34).
WARN CHECK Displays warning
concerning the
measurement results. See
“When you select “WARN
CHECK”” (page 36).
SAVE EXIT Saves the measurement
results and exits the setting
process.
RETRY Performs the Auto
Calibration again.
continued