Filter
Top Products
34
GB
3 Save the measurement result.
Select “SAVE EXIT” in step 2.
The measurement results are saved and
you can select the calibration type in the
AUTO CAL menu.
For details on calibration type, see page
36.
When measurement ends, “COMPLETE”
appears on the display and the settings are
registered as selected position number.
Note
You can select the position number to save the
Auto Calibration result. Select a position
number before you perform Auto Calibration.
For details, see page 36.
If you do not select the position number, the
Auto Calibration result will automatically save
as POS. 1 (initial setting).
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low frequency
characteristics.
The measurement results may vary, depending
on the position of the optimizer microphone
and speakers, and the shape of the room. It is
recommended that you follow the
measurement results. However, you can
change those settings in the SPEAKER menu
(page 48). Save the measurement results first,
then try to change the settings if you want.
When you select “PHASE
INFO.”
You can check the phase of each speaker (in
phase/out of phase).
Press V/v repeatedly to select a
speaker, then press to return to
step 2 in “Confirming/saving the
measurement results”.
* xxx represent a speaker channel.
FFront
FL Front left
FR Front right
CNT Center
S Surround
SL Surround left
SR Surround right
SB Surround back
SBL Surround back left
SBR Surround back right
SW Subwoofer
Tip
Depending on the position of the subwoofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
After you have finished
Disconnect the optimizer microphone from the
receiver.
Note
If you have reposition your speaker, we recommend
that you perform Auto Calibration again to enjoy the
surround sound.
Display Explanation
xxx* - IN The speaker is in phase.
xxx* - OUT The speaker is out of phase. The
“+” and “–” terminals of the
speaker may be connected the
other way around. However,
depending on the speakers,
“
xxx - OUT” appears on the
display even though the speakers
are connected properly. This is
because of the speakers’
specifications. In this case, you
can continue to use the receiver.