Filter
Top Products
135
US
D:\SONY HA\3289204121\01US-STRDA2400ESUC\110ADD.fm masterpage: Right
STR-DA2400ES
3-289-204-12(1)
Additional Information
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
Power Output
Rated Power Output at Stereo Mode
1)
(8 ohms 20 Hz – 20 kHz, THD 0.09%):
100 W + 100 W
Reference Power Output at Stereo Mode
(4 ohms 20 Hz – 20 kHz, THD 0.15%):
85 W + 85 W
Reference Power Output (8 ohms 1 kHz, THD
0.7%)
FRONT
2)
: 110 W + 110 W
CENTER
2)
: 110 W
SURROUND
2)
: 110 W + 110 W
SUR BACK
2)
: 110 W + 110 W
Reference Power Output (4 ohms 1 kHz, THD
0.7%)
FRONT
2)
: 100 W + 100 W
CENTER
2)
: 100 W
SURROUND
2)
: 100 W + 100 W
SUR BACK
2)
: 100 W + 100 W
1)
Measured under the following conditions:
120 V AC, 60 Hz
2)
Depending on the sound field settings and the
source, there may be no sound output.
Frequency response
PHONO RIAA equalization curve
± 0.5 dB
Analog 10 Hz – 100 kHz,
± 3 dB (with sound field
and equalizer bypassed)
Input
PHONO Sensitivity: 2.5 mV
Impedance: 50 kohms
S/N
3)
: 90 dB (A, 20 kHz
LPF)
4)
Analog Sensitivity: 150 mV/
50 kohms
S/N
3)
: 100 dB (A, 20 kHz
LPF)
4)
Digital (Coaxial) Impedance: 75 ohms
S/N
3)
: 96 dB
(A, 20 kHz LPF)
4)
Digital (Optical) S/N
3)
: 96 dB
(A, 20 kHz LPF)
4)
Output (analog)
AUDIO OUT Voltage: 150 mV/
1 kohm
SUBWOOFER Voltage: 2 V/1 kohm
Equalizer
Gain levels ±10 dB, 1 dB step
3)
INPUT SHORT (with sound field and equalizer
bypassed).
4)
Weighted network, input level.
FM tuner section
Tuning range 87.5 – 108.0 MHz
Antenna (aerial) FM wire antenna (aerial)
Antenna (aerial) terminals
75 ohms, unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
With 10-kHz tuning scale
530 – 1,710 kHz
5)
With 9-kHz tuning scale
531 – 1,710 kHz
5)
Antenna (aerial) Loop antenna (aerial)
Intermediate frequency
450 kHz
5)
You can change the AM tuning scale to either 9
kHz or 10 kHz. After tuning in any AM station,
turn off the receiver. While holding down
TUNING MODE, press POWER on the receiver.
All preset stations will be erased when you change
the tuning scale. To reset the scale to 10 kHz (or 9
kHz), repeat the procedure.
continued