Filter
Top Products
118
US
D:\SONY HA\3289204121\01US-STRDA2400ESUC\100REM.fm masterpage: Left
STR-DA2400ES
3-289-204-12(1)
1 Select a channel you want to
preset.
For details on this operation, refer to
“Selecting channels from a category
(CATEGORY TUNING)”.
2 Press SHIFT, then press ENT/
MEM.
You can also use MEMORY/ENTER on
the receiver.
“MEM” lights up on the display.
3 Press PRESET + or PRESET –
to select a preset number.
You can also select the number by
pressing SHIFT, then numeric buttons.
Preset numbers from 1 to 30 are available.
Channel 1 is preset for the preset numbers
when you purchase the receiver.
4 Press ENT/MEM.
If SHIFT indicator is light off before you
press ENT/MEM, press SHIFT.
You can also use MEMORY/ENTER on
the receiver.
“MEM” lights off.
5 Repeat steps 1 to 4 to preset
another channel.
Selecting a preset channel
1
Press XM to select “XM RADIO” or
press SIRIUS to select “SIRIUS”.
2 Press PRESET+ or PRESET –
repeatedly to select the preset channel
you want.
You can also press SHIFT, then numeric
buttons to select the preset channel you
want. Then, press ENT/MEM to enter the
selection.
You can also press TUNING MODE on the
receiver repeatedly to select “PRESET”
then use TUNING +/– to select the preset
channel you want.
Operating each
component using the
remote
When you program the remote to control the
following Sony or non-Sony components, you
can use the buttons on the remote that are
marked with circles. Note, however, that some
buttons may not operate your component.
If you want to change the contents of the input
list to match your particular components, see
“Programming the remote” (page 120).
Presetting satellite tuner
channels
Using the Remote