Filter
Top Products
Troubleshooting
M8501 and M8502 ACL Tape Drive Installation and User’s Guide—529972-001
6-4
Fault Symptom Codes (FSCs)
SCSI FIFO Error 1003 D, G The SCSI controller data FIFO should be
empty but still contains data bytes.
SCSI Gross Error 1004 C, D, G The SCSI controller detected a gross
error condition - invalid SCSI bus phase
or DMA error.
Illegal SCSI Cnt Cmd 1005 C, D, G Either an invalid command was sent to
the SCSI controller, or the controller was
not in the correct mode.
SCSI Invalid Element 1007 D, G Internal SCSI task processing error -
invalid element type was detected.
SCSI Invalid Int. 1009 D, G The SCSI controller posted an invalid
interrupt status.
Loader Not Ready 2004 C, G Fail to fetch, stow, scan, move passthru,
Or when loader detects invalid command,
aborts command.
Door Open (status
only)
2009 F Door is force opened or door sensor
failed.
Cart Inaccessible 200C F For an LTO, indicates the tape is not
ejected. Cartridge in drive is not
accessible from changer.
Drive In Error 200D C, G A general drive error detected by control
task.
No Magazine 200E F Cannot move, element not installed, from
changer.
Removal Prevented 200F F Receive medium prevent removal from
drive for a fetch.
Ctl. Firmware Error 2010 C, G Internal inter task processing error.
Unexpected event. SMX send or receive
error.
Drive Time-out Error 2030 C, G Can’t communicate with DLT drive.
Drive Code Update
Command Error
2080 C, G Update code from SCSI or from TAPE
failed.
Move Command
Failure
2081 C, G Move command from / to drive slot failed,
detected by control task.
Open Mail Slot Fault 2090 C, G Door open sensor time-out detected when
open door.
Open Left Door Fault 2091 C, G Door open sensor time-out detected when
open door.
Open Right Door Fault 2092 C, G Door open sensor time-out detected when
open door.
Table 6-2. Fault Symptom Codes
Message FSC ERP