Smart Technologies 240 Stereo System User Manual


 
Product Registration
If you register your SMART product, we'll notify you of new features and
software upgrades.
Register online at
www.smarttech.com/registration
.
Keep the following information available, in case you need to contact
Technical Support:
Serial Number
Date of Purchase
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation.
You can determine whether the equipment is causing interference by disconnecting it from your computer. If the interference stops, it
was probably caused by the equipment.
Trademark Notice
SMART Audio, smarttech and the SMART logo are trademarks or registered trademarks of SMART Technologies ULC
in the U.S. and/or other countries. All other third-party product and company names may be the trademarks of their
respective owners.
Copyright Notice
© 2008–2009 SMART Technologies ULC. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval
system or translated into any language in any form by any means without the prior written consent of SMART Technologies ULC. Information in this
manual is subject to change without notice and does not represent a commitment on the part
of SMART.
Patent Nos. US6320597; and US6326954. Other patents pending.
Printed in Japan 04/2009