Filter
Top Products
10 Installing Your SMART Audio 240 System 99-00855-20 C0
Installing the Wall Speakers
Complete the following procedures for each wall speaker.
1. Place the wall speaker’s mounting bracket on the wall where you want to install
the speaker.
2. If you’re attaching the speaker to a stud wall, use a carpenter’s level to straighten the
bracket on the wall, and then tighten two screws appropriate for the stud through the
bracket’s screw holes and into the stud.
OR
If you’re attaching the speaker to a cinder block wall, use a carpenter’s level to straighten
the bracket on the wall, and then trace the two screw holes with a pencil.
a. Remove the mounting bracket and drill screw holes with a power drill.
b. Using a carpenter’s level to straighten the bracket on the wall, tighten two concrete
mounting screws through the bracket’s screw holes and into the wall.
3. Pull down on the bracket to test that the mounting bracket is secure.
4. Place the speaker between the two arms of the mounting bracket.
5. Tighten the two bracket bolts through the arms of the bracket and into the speaker.
6. Gently pull on the speaker to test that the speaker is secure in its bracket.
1. Run the speaker wires from the receiver to the wall speaker.
2. Connect the positive cable to the speaker’s positive (red) terminal.
3. Connect the negative cable to the speaker’s negative (black) terminal.
To attach a wall speaker to the wall
To attach the speaker cable to the wall speaker
WARNING
Ensure that you bundle and mark cables extending across the floor to your
SMART Audio 240 system to avoid a trip hazard.