Filter
Top Products
32
5 Bring the cable out from the trim near the front of the cabin and route
it under the carpet toward the dashboard or console. Coil any excess
cable in a hidden location, such as under the carpet, keeping it away from
any vehicle pedals or controls. Secure the excess cable with wire ties
(purchased separately).
6 Bring the end of the cable out at the PowerConnect Vehicle Dock location.
Leave yourself enough cable so you can easily connect it to the antenna
connector of the dock.
7 Continue with “Step 5: Connect the Magnetic Mount Antenna and
PowerConnect Power Adapter” on page 37.
Sedan/Coupe With Antenna Placed at the Front of the Roof
1 Feed the antenna cable from the antenna underneath the rubber molding
around the windshield. Use a blunt plastic putty knife or similar blunt tool
to lift the rubber molding around the windshield and tuck the antenna
cable underneath the molding. Route the antenna cable around and down
the windshield to the lowest point.
2 At the lowest corner of the windshield, route the cable out of the
windshield molding and into the rubber weather stripping around the
door opening. Lift the weather
stripping from the opening and
tuck the cable inside it, then
replace the weather stripping.
Run the cable inside of the
weather stripping to the bottom
of the door opening.
3 Pull the cable out of the
weather stripping at the bottom
Vehicle Installation