Filter
Top Products
16
Vehicle Installation
Step 2: Install the Vent or Dash Mount
Depending on your situation, you can either choose to use the Dash Mount or the
Vent Mount.
Installing the Dash Mount:
CAUTION! The adhesive used on the Dash Mount may be difficult to remove. Do not
install this mount on leather surfaces (contact your vehicle dealer if you are unsure
about your dash surface), and make sure the air temperature is at
least 60ûF (15ûC) during installation. If it’s not at least 60ûF, turn on
the heater in your vehicle to bring the temperature up to 60ûF.
1 Locate a flat surface for the Dash Mount. Make sure
there is ample room for the PowerConnect Vehicle Dock
and Stratus 6 when installed.
2 Set the orientation of the Dash
Mount before adhering it. Loosen
the knob and adjust the adhesive
foot for the location you selected
in “Step 1: Choose a Location for
Your Radio” on page 14:
•Option 1 & Option 3 should be oriented
as I.
•Option 2 should be oriented as II.
3 Attach the Dash Mount to the
PowerConnect Vehicle Dock using the
provided screws.
I
II