Sirius Satellite Radio EQ-SIRRCV Satellite Radio User Manual


 
4. Plug the NON-THREADED connector on the antenna cable into the receptacle labeled ANTENNA on the upper right end of the receiver. If
you must increase the distance between the antenna and the receiver, we stock 50-foot amplified extension cables (AMTC P/N EQ-SIR50X)
for $39.95 (+ $5.00 S/H). Up to two of these may be daisy-chained together for a total extension of 100 feet. IMPORTANT!: To unplug
the antenna cable, grab the CONNECTOR and pull firmly. DO NOT PULL BY THE CABLE! Failure to heed this warning could cause the
connector to become detached from the cable.
Positioning the Receiver and Connecting to Your Amplifier
The receiver should typically be positioned as close as possible to the amplifier into which it will be connected. The provided audio cable is
6 feet long. If you prefer to position your receiver further than 6 ft. from your amplifier, we stock inexpensive 25-foot audio extension
cables, as well as couplers to "daisy-chain" the extension cables. Our labs have tested daisy-chaining four extension cables, for a length of
100 feet, with no noticeable loss of signal. Call AMTC at 800-741-AMTC(2682) for further information or to order.
Connect the 3.5mm stereo plug on the provided audio cable to the receptacle labeled “AUDIO OUT” on the lower right end of the receiver.
3.5mm stereo plug
If your amplifier is stereo:
Connect the dual RCA plugs of the provided audio cable into the L and R auxiliary inputs of your amplifier. Do NOT connect to the
PHONO input.
dual RCA plugs
If your amplifier is mono:
Connect the dual RCA plugs of the provided cable into the dual jacks of the provided 25cm dual RCA female to single RCA male (stereo to
mono) adapter cable:
25cm dual RCA female to single RCA male (stereo to mono) adapter cable
Connect the single RCA plug into the RCA input jack of your amplifier. If your amplifier has a 1/4” input jack, use the provided RCA female
to 1/4" male mono adapter:
RCA female to 1/4" male mono adapter
Connecting Power
A 12VDC 1.2A power adapter is provided with the receiver. The adapter should be plugged into the jack labeled “DC12V” on the upper left
end of the receiver, and into 110-120 VAC wall power. Avoid using a circuit also powering any heavy equipment or appliances, particularly
air conditioners or refrigeration equipment. We highly recommend that you use a quality surge protection device to protect your receiver.
4