Filter
Top Products
- 6 -
General functions
Key lock
In order to prevent changing the settings unintention-
ally by touching the buttons, you can activate the
key lock.
• Press and hold down the
MEM button for around
3 seconds. The screen will flash . All but-
tons except the
SNOOZE button are now locked.
• Press and hold down the
MEM button again for
about 3 seconds to cancel the key lock. The
message on the screen disappears.
Screen lighting
• Press any button to illuminate the screen.
The screen will remain lit for about10 seconds.
Stand
• Flip out the stand on the rear of the device
to enable it to stand more stably.
Time functions
The time functions can only be set when the radio is
switched off. If the time cannot be set using the RDS
signal, the default time of the world receiver starts at
0:00 00.
The settings are lost if the device is disconnected
from its power supply.
Time, date, time zone and world time
You can use the MODE button to set the time, date
and time zone, query the world time and set the
date alarm, medium wave reception, alarm time
reception, hourly mode and time update.
When you press MODE, the function to be set flashes
for about15 seconds. During this time, adjust the
setting with the
UP/DOWN buttons.
• Press
MODE x1: Set clock time.
• Press
MODE x 2: Set the date.
• Press
MODE x 3: Set time zone
(„Local city”).
• Press
MODE x 4: Show world time.
• Press
MODE x 5: Date alarm.
• Press
MODE x 6: Set reception range for
medium wave.
• Press
MODE x 7: Set alarm pause.
• Press
MODE x 8: Set 12/24 hour mode.
• Press
MODE x 9: Set automatic time query.
To apply a setting, just wait until the screen stops
flashing (the screen reverts to the time indication)
or press
MODE to move on to the next function.
Setting clock time
• Press MODE once. The most recently set time
flashes on the screen.
• Press the
UP or DOWN button to move the time
forward or backward at minute intervals.
Hold down one of the buttons for a few
seconds to move the setting forward or
backward quickly at10 minute intervals.
Note:
Set the time without summer time offset.
If summer time is required, this can be set
when setting the time zone (see below).
IB_KH2029_AR23586_LB3C 18.08.2008 15:56 Uhr Seite 6