Filter
Top Products
- 12 -
Setting the MW band
Since the radio transmitter systems differ from one
country to another, you should make the appro-
priate setting via the reception range setting:
• Press the
MODE button six times and then use the
UP or DOWN button to select the corresponding
reception range as per the following table:
Region Channel spacing Band range
America 10 kHz 520–1710 kHz
Europe 9 kHz 522–1656 kHz
Fine tuning
If a station can not be found precisely the fine
tuning can be use to improve reception.
• During the channel search press the FINE
button, the screen shows FINE.
• The
UP and DOWN buttons can now be used to set
the desired frequency in half frequency steps.
• By pressing the
FINE again you leave the fine
tuning function again.
This function is not available for the LW frequency
range.
Aerial
The rotatable telescopic aerial on the radio can be
used for the FM and SW bands.
• Pull the aerial out fully and arrange it for
optimum reception.
The SW SEN. switch on the left side of the device
can be used to improve the reception quality for
the SW band. Select LX for strong stations and RX
to improve reception for weak stations.
The telescopic aerial does not work in the MW and
LW bands. In these bands, the radio uses its built-in
ferrite aerial.
• Align the radio for best reception.
Memory functions
Save station
The world receiver can save 400 stations in each
frequency range.
To store a station, proceed as follows:
• Set the frequency range with the frequency
selection switch and then the station that you
want to save (see above).
• Press the
MEM button. The screen shows the
PAGE memory page and MEM flashes.
• Within 10 seconds press the
PAGE button
(the PAGE message flashes), and then select
a memory page (from 00–39) using the
UP
or DOWN button.
• Within 10 seconds use the
M.0/5–M.4/9 buttons
to select a memory space to store the station. For -
example, press the
M.0/5 button once for memory
space 0 and again for memory space 5. The oc-
cupancy is shown on the screen.
• Press
MEM again to save the station. The PAGE
and MEM messages are shown on a perma-
nent basis.
Note:
If the world receiver is connected to the mains
adapter and no batteries have been inserted,
the station memories are lost when the adapter
plug is pulled from the socket.
IB_KH2029_AR23586_LB3C 18.08.2008 15:56 Uhr Seite 12