Filter
Top Products
ENGLISH
ENGLISH
– 14 –
RECEIVER MOUNTING
Table Mounting
To mount a receiver on a table or other horizontal surface, attach the four adhesive bumpers to the bottom corners
of the receiver and place the receiver on the mounting surface. See Figure 20.
RUBBER FEET
R
TABLE MOUNTING THE UC4 RECEIVER
FIGURE 20
Rack Mounting a Single Receiver
To mount a single receiver in an audio equipment rack, select the single rack mounting kit supplied with the system
and proceed as follows:
1. Remove the two screws from each side of the receiver. See Figure 21.
2. Position the large mounting bracket over the holes on one side of the receiver and secure them with the screws
removed in Step 1. One of the brackets will be longer than the other.
UC4 RECEIVER
(TOP VIEW)
BRACKET
BRACKET
FRONT
UC4 RECEIVER
(TOP VIEW)
EQUIPMENT RACK
ANTENNA
HOLE PLUG
ANTENNA
HOLE PLUG
FRONT
RACK MOUNTING A SINGLE UC4 RECEIVER
FIGURE 21
NOTE: If you are not front mounting the antennas with a UA600 Front Mount Conversion Kit, insert the plastic plugs
into the bracket holes.
3. Secure the receiver to a 19-inch audio equipment rack, using the four supplied screws.