Filter
Top Products
Adjusting the speaker settings
ENGLISH
12
With the receiver in any of the
surround modes, press the
SPEAKER MODE button for
more than 2 seconds to enter
the front-center-rear speaker
set-up mode.
1
Select the desired speaker
setting.
2
The existing front-rear-center speaker setting is
displayed.
This set-up mode is not available when 6 CH DIRECT
is selected as the input source or when ANALOG is
selected as the signal input in the STEREO mode.
This receiver is equipped with circuitry that allows
the use of a wide range of speaker systems.
This circuitry works by redirecting the bass
frequencies or the entire channel to speakers that are
capable of reproducing them.
When a large or full range speaker capable of deep
bass response is used for one of the channels, that
channel should be set to L.
When a small or satellite speaker with limited bass
capability is used, that channel should be set to S.
Deep bass from that channel will be redirected to the
main left and right speakers or to the subwoofer.
When there is no speaker available, that channel
should be set to N. All the information in that
channel will be redirected to other available speakers.
Each time this button is pressed, one of 11 different
speaker settings is selected and displayed for 8
seconds as follows;
FLCSRS, FLCLRS, FLCLRL,
FLCLRN, FLCSRL, FLCNRL,
FLCSRN, FLCNRS, FSCSRS,
FSCSRN and FSCNRS.
In the above, F stands for Front Speakers, C for
Center Speaker, R for Rear Speakers, L for Large,
S for Small and N for None.
Large speakers are capable of deep bass response
and typically have one driver with a cone that is
10(25 cm) or larger.
The following speaker settings cannot be selected:
Front, Small : Center, Large : and Rear, Large(FS--
CL--RL) : or Center, None and Rear, None(CN--
RN).
SPEAKER MODE
SPEAKER MODE
Select the desired
subwoofer setting.
4
Your requested speaker settings are entered into
memory and the set-up procedure advances to the
subwoofer mode.
If the speaker setting display disappears before the
MEMO/ENTER button is pressed, you must start
again from Step 1, above.
Each time this button is pressed, the subwoofer
setting changes and is displayed for 8 seconds as
follows;
SUB W(oofer) -- Y(es): When using a powered
subwoofer.
SUB W(oofer) -- N(o) : When not using a powered
subwoofer.
If the front speakers are set to S(mall), the
subwoofer is automatically set to “Y”.
MEMO/ENTER
SPEAKER MODE
SPEAKER MODE
Memorize the desired speaker
settings. Press the MEMO/
ENTER button while your
choice is displayed.
3
Your requested subwoofer setting is entered into
memory.
If the subwoofer display disappears before the
MEMO/ENTER button is pressed, you must start
again from Step 2, above.
Each time this button is pressed briefly, the front-
center-rear speaker or subwoofer setting is
displayed.
MEMO/ENTER
Memorize the subwoofer
setting. Press the
MEMO/ENTER button while
your choice is displayed.
5
Checking the speaker setting
ADJUSTING SPEAKER SETTINGS
Operations