ENGLISH
22
Operating the sleep timer
The sleep timer allows the system to continue to
operate for a specified period of time before
automatically shutting off.
To set the receiver to automatically turn off after
the specified period of time.
Each time this button is pressed, the sleep time
changes and disappears in 3 seconds as follows;
10 20 30 60 90 OFF
Unit : minutes
While operating the sleep timer, “SLEEP” lights up.
Compressing the dynamic range (Dolby Digital sources only)
This function compresses the dynamic range of previously
specified parts of the Dolby Digital sound track(with
extremely high volume) to minimize the difference in
volume between the specified and non-specified parts.
This makes it easier to hear all of the sound track when
watching movies at night at low levels.
When the digital signals from Dolby Digital program
source are input in available surround mode.
Each time this button is pressed, the mode changes
and disappears in 3 seconds as follows:
DYNR 0.0 : Off
DYNR 0.5 : Low compression
DYNR 1.0 : High compression
In some Dolby Digital software, this function may
not be available.
Each time this button is pressed, the brightness of
fluorescent display changes as follows;
ON
dim
OFF
In the display OFF mode, pressing any button will
restore the display ON mode.
The audio signal from the CD and the video signal
from the VIDEO 2 will be dubbed and you can
enjoy them on the TV set and from the speakers.
Note : Be sure to observe the order of the above steps
1 and 2.
Start recording on the VIDEO 1.
3
Adjusting the brightness of the
fluorescent displays
Start play on the VIDEO 2 and the CD
respectively.
4
OTHER FUNCTIONS
DYNAMIC
RANGE
POWER
DISPLAY
SLEEPVIDEO1
123VIDEO2
456VIDEO3
789CD
T.TONE
0 P.SCANTUNER
DSP MODE
D.TIMEADJUST AUX
MUTE T.MON
CH. LEVEL
CH. SEL
MASTER VOLUME
REMOTE CONTROL UNIT RM-105
DISPLAY
AUTO
POWER
DISPLAY
SLEEPVIDEO1
123VIDEO2
456VIDEO3
789CD
T.TONE
0 P.SCANTUNER
DSP MODE
D.TIMEADJUST AUX
MUTE T.MON
CH. LEVEL
CH. SEL
MASTER VOLUME
REMOTE CONTROL UNIT RM-105
SLEEP
AUTO