Filter
Top Products
ENGLISH
16
Adjusting the speaker settings
Press the SPEAKER
MODE button for more
than 2 seconds to enter the
front-center-rear speaker
mode.
6
Select the desired speaker
setting.
7
The front-center-rear speaker setting is displayed.
When the SPEAKER button is set to off or the 6 CH
DIRECT is selected as an input source, the speaker
mode function cannot be available.
When it is in the stereo or Dolby Virtual mode, only
the subwoofer setting can be adjusted.
If the parameter display disappears, start from the
step 3 again.
Adjust the settings of front, center ,rear speakers and
subwoofer connected.
If the speaker setting is adjusted to “S”, the low range
bass sound of the channel(s) is redirected to the
subwoofer or the front channels and if the speaker
setting is adjusted to “N”, the sound of the channel(s)
is redirected to other channels.
Each time this button is pressed, one of 11 different
speaker settings is selected and displayed for 8
seconds as follows;
FLCSRS, FLCLRS, FLCLRL,
FLCLRN, FLCSRL, FLCNRL,
FLCSRN, FLCNRS, FSCSRS,
FSCSRN and FSCNRS
In the displays, F stands for Front, C for Center, R
for Rear, L for Large, S for Small and N for None.
When judging whether a speaker is Large or Small,
please note that a standard large speaker can fully
reproduce sounds below 80 Hz.
The following speaker settings cannot be selected.
Front :Small, Center : Large and Rear : Large(FS-
CL-RL) or Center : None and Rear : None(CN-RN)
setting.
SPEAKER
MODE
Select the desired
subwoofer setting.
9
The desired speaker setting is memorized and then
it enters the subwoofer mode.
If the speaker setting display disappears, start from
the above step 6 again.
Each time this button is pressed, the subwoofer setting
changes and is displayed for 8 seconds as follows;
SUB W(oofer) - Y(es): When using a subwoofer.
SUB W(oofer) - N(o) : When not using a subwoofer.
In case that the front speaker is set to “S”, the
subwoofer is automatically set to “Y”.
MEMO/ENTER
MEMO/ENTER
Memorize the desired
speaker setting
while it is displayed.
8
Repeat the above steps 3 and 4 to adjust
other parameters.
5
Note:
In the Dolby Pro Logic II Customer mode, you cannot set both of
the 7 kHz Low Pass Filter and Shelf Filter to ON simultaneously.
If so, the filter set previously is automatically changed to OFF.
ADJUST
ADJUST
ADJUST
At the desired parameter,
adjust it as desired.
4
If the subwoofer setting display disappears, start
from the above step 6 again.
Each time this button is pressed briefly, the front-
center-rear speaker or subwoofer setting is displayed.
Memorize the subwoofer
setting while it is
displayed.
10
Checking the speaker setting
SPEAKER
MODE