Filter
Top Products
• Each time the "ON/STANDBY" button on the front
panel is pressed, the ROOM2 mode changes as
follows :
R2 > OFF
ROOM2 off mode ("R2" turns off)
R2 > input display : ROOM2 on mode
("R2" lights up)
• On the remote control, press the POWER ON
button to turn on the ROOM2 mode or press the
STANDBY button to turn it off.
Note :
• Only while displaying the ROOM2 on mode, you
can adjust the ROOM2 settings.
21
ROOM2 PLAYBACK
• This function allows enjoying one source in the main room and playing another in a different room at the same
time.
• Even when this receiver enters the standby mode, in such a case that "R2" is dimly lit, meaning only the ROOM2
circuitry operates, the ROOM2 source can be played independently. Therefore, when you do not use the ROOM2
function, turn off the ROOM2 function to save electricity.
• To enjoy ROOM2 source, turn on the ROOM2 function and adjust the ROOM2 settings as below.
• "R2 > ~ " is displayed for several seconds.
• Each time this button is pressed, the mode is
changed to the ROOM2 mode ("R2 > ~") or the
main mode (main input display).
• When "R2 > ~" is not displayed, press this button
again.
Note :
• Only while displaying the ROOM2 mode, you can
set the ROOM2 mode.
1. Enter the ROOM2 mode.
2. Turn on the ROOM2 mode.
3. Select the desired ROOM2 speakers.
• Each time the SPEAKER C/D SELECTOR button is
pressed, the speakers are switched on or off as
follows:
R2 C/D R2 - / - R2 C/ - R2 - /D
Note :
• Only when the ROOM2 mode is set to on, the
speakers C or/and D can be used as ROOM2
speakers.
RX-5502(G) 2007.8.17 4:33 PM 페이지 21