ENGLISH
8
■ ROOM 2 connections
• To control this unit from a remote location, connect this jack
to the output of the multi-room adaptor.
For information on the multi-room system kit, contact the
Xantech corporation at 1-800-843-5465 or www.xantech.com.
• These outlets are switched on(power-on
mode) and off(standby mode) according
to the power control as follows(Maximum
total capacity is 1A, 100W):
Standby mode – switched AC outlet off
Power-on mode – switched AC outlet on
■ SWITCHED AC OUTLETS
• If another A/V receiver or integrated amplifier, etc. is connected to these jacks, you can play a different program source in another
room as well as one source in the main room at the same time.(For details, refer to "ROOM 2 SOURCE PLAYBACK" on page 31).
• When the multiroom adaptor is connected to control this unit in another room, the ROOM 2 function is more convenient.
Note:
• To minimize hum or noise, use high quality connection cords in such a way that there is no humming or noise.
■ AC INLET
Plug the supplied AC input cord into this AC
INLET and then into the wall AC outlet.
To a wall AC
outlet.
• Do not use an AC input cord other than the one
supplied with this unit. The AC input cord
supplied is designed for use with this unit and
should not be used with any other device.
■ CONNECTING MULTI-ROOM
SYSTEM KIT
• Never short circuit the + and - speaker wires.
• Be sure to connect speakers firmly and correctly according to the
channel (left and right ) and the polarity ( + and -).
• Be sure to use speakers with the impedance of over 6 Ω.
• Only when enjoying either 6.1 or 7.1 channel surround playback,
connect the surround back left speaker only or both of surround
back speakers.
Note:
• After installing the speakers, first set the connected speakers to the
desired before operating this receiver.(For details, refer to
"SETTING THE SPEAKER SETUP" on page 34.)
■ CONNECTING SPEAKERS
Front right
Front left
Surround
left
Surround
right
Surround back
right
Front
center
Surround back
left
OUT
Another room
Adaptor
(Multi-room system kit)
IR receiver
(Multi room system kit)
Remote control unit
DVD
VOL.
CH LEVEL
OSD
CH SEL
INTRO
RETURN
DSP
MODE
AUTO
ST
CENTER
MODE
TEST
TONE
DISC
P.SCAN
TUNER
CD
T1/MONAUX
PHONO
VID1VID2VID3VID4VID5
SYS DISPSLEEP
DIRECT IN
ROOM2
RPT
AB
7.1 SURR
TITLE
ENTER
HOME THEATER MASTER
RNC-220
Another room
VIDEO IN
AUDIO IN
VIDEO IN
Monitor TV
Speakers
A/V receiver
or amplifier