Filter
Top Products
12
ENGLISH
LOADING BATTERIES
OPERATING COMPONENTS WITH REMOTE CONTROL
1 2
DVD
VOL.
CH LEVEL
OSD
CH SEL
INTRO
RETURN
DSP
MODE
AUTO
ST
CENTER
MODE
TEST
TONE
DISC
P.SCAN
TUNER
CD
T1/MON AUX
PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISP SLEEP
DIRECT IN
ROOM2
RPT
AB
7.1 SURR
TITLE
ENTER
HOME THEATER MASTER
RNC-220
CHANNEL
SELECTOR
ON/OFF
PHONES
SPEAKER
TUNING/PRESET
VIDEO LABEL
ROOM2 FEED
AUDIO/VIDEO SURROUND RECEIVER
R-863
MULTI CONTROL
DYNAMIC
RANGE
T/P MODE
MASTER VOLUME
ON/STANDBY
STANDBY
POWER
BAND CINEMA EQ
MEMO/ENTER
ON /OFF
S-VIDEOOPTICAL IN VIDEO L
-
AUDIO
-
R
WIDE RANGE AMPLIFIER STAGE
W
RAS
INPUT SELECTOR
AUDIO VIDEO DIGITAL/ANALOGEXTRA SURR.
6.1
/
7.1
STEREOTAPE MON.7.1CH DIRECTDECODING
SURROUND MODE
LOCKLOCK
7m
30
30
MULTI ROOM
REMOTE SENSOR
SOURCE
DIRECT
TONE MODE
TEST TONE
REMOTE CONTROL OPERATION RANGE
• Use the remote control within a range of about 7
meters (23 feet) and angles of up to 30 degrees
aiming at the remote sensor.
Remove the cover.
Load four batteries(“AAA” size, 1.5 V)
matching the polarity.
When this remote control does not operate the component, the old batteries should be replaced.
If the batteries are removed for a longer period of time, the remote control might lose its memory and require
reprogramming
• When a button is pressed, the corresponding DEVICE
button flickers.
• When operating a Sherwood CD player or tape deck
using the system remote control, aim the remote
control at the REMOTE SENSOR on this unit.
• However, in case of Sherwood DVD player, aim it
at the REMOTE SENSOR on the corresponding
component.
Enter the setup code of the components
respectively, referring to “ENTERING A
SETUP CODE”(page14).
Turn on the components you want to
operate.
1
Press the DEVICE button on the remote
control corresponding to the component
you want to operate.
2
Press the button corresponding to the
operation you want while aiming the
remote control at the REMOTE SENSOR
on the component.
3
4