Filter
Top Products
ENGLISH
Universal Remote Controls
10
• This section explains the basic functions for Sherwood or OSD mode. For the non-Sherwood mode, refer to the
operating manual of this remote control.
• All Sherwood components bearing the DIGI LINK (II or III) logo can be used with this remote control.
• For system remote control operation, first make the DIGI LINK connections between Sherwood components.
• The numbered buttons on the remote control have different functions in different modes. For details, refer to the
“FUNCTION TABLE of the NUMBERED BUTTONS” on the following page.
• In the DIGI LINK III remote control system, if pressing PLAY, etc. on CD player or tape deck, CD or TAPE
MONITOR is selected automatically on the receiver without selecting the input source. Then PLAY, etc. starts.
Note: For enhanced Universal Remote Programming instructions and manufacturer’s codes, please refer to the operating
manual inclosed with this Universal Remote Control.
This remote control has 3 operating modes as follows:
• OSD (On-Screen Display) mode: Allows you to look at information about basic operation of this unit on your monitor TV
and to operate this unit by moving an arrow that appears on the screen of your monitor TV.
• Sherwood mode: Allows you to operate this unit and other Sherwood components like cassette decks, CD players, etc.(To
operate other Sherwood components, you should make the DIGI LINK connections between them.)
• Non-Sherwood mode: Allows you to operate other non-Sherwood audio and video components that are remote compatible.
Notes:
• The setup code for each component must be entered before operation.
• For setup codes(manufacturer’s codes), please refer to “Set-Up Code Tables” in the operating manual of this remote
control.
• Some operation buttons have different functions according to each operation mode.
• Be sure to set the remote control to the correct mode before operation.
DIGI LINK SYSTEM REMOTE CONTROLS
DVD
VOL.
CH LEVEL
OSD
CH SEL
DSP
MODE
AUTO
ST
CENTER
MODE
TEST
TONE
DISC
P.SCAN
TUNER
CD
T1/MON AUX
PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISP SLEEP
DIRECT IN
ROOM2
INTRO
RETURN
B
RPT
A
7.1 SURR
TITLE
ENTER
HOME THEATER MASTER
RNC-220
LED LAMP
DEVICE BUTTONS
To operate the desired component with this remote
control, first select the corresponding DEVICE button.
POWER BUTTON
ENTER BUTTON
NUMERIC(1~0) BUTTONS
• For selecting preset stations in tuner mode.
• For selecting a track or a disc in CD mode, etc.
• When selecting a disc, select disc No. (1~5) within 2 sec.
after pressing DISC(marked "P.SCAN") button.
LIGHT BUTTON
Activates the backlighting of the remote control
for 7 sec. If any other button is pressed while
the backlighting is on, the remote control will
remain backlit for an additional 7 sec.
VOLUME UP/DOWN( / ) BUTTONS
CHANNEL LEVEL UP/DOWN( / ) BUTTONS
CURSOR CONTROL( , , , ) BUTTONS