Filter
Top Products
ENGLISH
11
FUNCTION TABLE of the NUMBERED BUTTONS
• This remote control can control up to 4 different components.
• Before operating video components other than this unit with using this remote control, the setup code for each component
should be entered.
ENTERING A SETUP CODE
Find the setup code according to the type and
the brand name of your component, referring
to “Setup Code Table” on page 56.
2
Turn on the component you want to control
1
Enter a 3 digit code, aiming the remote
control at the remote sensor on the
component.
Example) When entering “001”.
4
• The SET LED will flicker once.
Note:
• The MAIN button is unavailable for the components other
than this unit.
• If entering is performed successfully, the SET LED will
flicker twice.
• To be sure that the setup code is correct, press the
POWER button. If your component is turned off, the setup
code is correct.
• When your component is not turned off, repeat the above
steps 2 to 4, trying each code for your component until
you find one that works.
Notes:
• If the SET LED did not flicker twice, then repeat the above
steps 3 to 4 and try entering the same code again.
• Manufacturers may use different setup codes for the
same product category. For that reason, it is important
that you check to see if the code you have entered
operates as many controls as possible. If only a few
functions operate, check to see if another code will work
with more buttons.
Press and hold down both the ENTER
button and the DEVICE button you want for
more than 1 second.
3
Repeat the above steps 1 to 4 for each of
your components.
5
Notes:
• Some functions for each component may not be available or may work differently.
• Depending on other kinds of components that are available for each DEVICE button, some functions may not be available or
may work differently, too.
• For details about functions, refer to the operating instructions of each component.