Filter
Top Products
217
EAN-13
• Ordinary EAN-13 code (used in the source marking)
• Specific EAN-13 code (flag 977, 978, 979) (used in the source
marking: ISBM, ISSN)
For entry, you must enter a full of 13 digit number.
• Internal code (used for in-store marking, the flag character
number: 20 through 29 and 02)
Program the format in “EAN NON-PLU” in ARTICLE setting.
Add-on code
UPC-A and EAN-13 may be followed by a two digit number or a five digit number as an add-on code,
except the UPC-A without a check digit plus two or five digit add-on code.
Therefore, the total number of digits enterable for sales entries are as shown below:
Code entry No add-on code 2-digit add-on code 5-digit add-on code
UPC-A 12 14 17
UPC-A w/leading zero 13 15 18
UPC-A w/o check digit 11 ––
UPC-E 6 ––
EAN-8 8 ––
EAN-13 13 15 18
NOTE
Your register automatically judges the add-on code in an EAN code entered from the total
number of digits and the flag.
UPC file
Your POS terminal has a UPC main file and can provide a Dynamic UPC (D-UPC) file.
UPC main file
In general use, all UPC items are managed in the UPC main file.
The programming data and sales information is recorded in the UPC main file.
Dynamic UPC file
If the dynamic UPC file is allocated, the items entered by the UPC learning function (refer to “UPC
learning function” section.) are saved in this file temporarily. (If not generated, they are directly saved in
the UPC main file.) The data saved temporarily can be transferred to the UPC main file when necessary
by executing the D-UPC LOAD in the PGM2 mode.
If you want to use the dynamic UPC file, please consult your authorized SHARP dealer.
C
D
Maker code
Nation code
Item code
C
D
(Free format)
Program the format in EAN NON-PLU.
Flag
02, 20-29