Filter
Top Products
<P=002>
(Continued)
2
1
4
3
4
■ ASPM (Auto Station Program Memory)
It is recommended that you store stations in memory using ASPM.
(This memory can be used for PTY searches and EON switching.)
When the ASPM button is pressed, whilst tuned to the FM band, the RDS (Radio
Data System) function will automatically search for new RDS stations. Up to 40
stations can be stored in memory. (If you have already stored some stations in
memory, the number of new stations you can store will be less.)
1 Press the ON/STAND-BY button to turn the power on.
2 Press the TUNER (BAND) button.
3 Press the ST-MODE button to select the FM ST or FM band.
4 Press and hold down the ASPM button for at least 3 seconds.
①After "ASPM" has flashed for about 4 seconds, scanning will start. (87.50 -
108.00 MHz )
②When an RDS station is found, the RDS will appear for a short time and the
station will be stored in memory.
③After scanning, the number of stations that have been automatically stored in
memory will be displayed for 4 seconds, and then "END" will appear for 4
seconds.
Notes:
● Only RDS stations will be stored in memory.
● If the same station is broadcasting on different frequencies, the transmission
with the strongest broadcast frequency will be stored in memory.
● Any station which has the same frequency as one which has been already stored
in memory will not be stored again.
● If a 40th station is stored in memory during a scan, the scanning will stop at
that station. The number of stations and "**MEMORY END" will each be dis-
played for 4 seconds.
● If no stations have been stored in memory, "0MEMORY END" will flash for about
4 seconds.
● If 40 stations have already been stored in memory and the ASPM button is
pressed, "0MEMORY END" will appear immediately and the scan will be aborted.
If you want to redo the ASPM operation from the beginning, erase the preset
memory, and then perform steps 1 - 4.
To stop the ASPM operation before it is complete:
Press the ASPM button whilst it is scanning for stations.
● The stations that have already been stored in memory will be kept there.
To erase all of the contents of preset memory:
The unit is in the stand-by mode.
Hold down the TRACK EDIT button and the ENTER button, and then press the
ON/STAND-BY button.
● After performing this operation, all of the preset memory information will be
erased.
(Remote control operation)
(4 seconds)
MD-X60H(SUK) TINSE0227AWZZ
15