Sharp CP-S10H Stereo System User Manual


 
04/10/21 XL-MP10H(A)E2.fm
20
TINSEA036SJZZ
XL-MP10H
Tape Recording
Recording on a cassette tape (continued)
To perform programmed recording:
To interrupt recording:
Press the button.
To resume recording, press the button.
To stop recording:
Press the button.
The tape will stop.
! Recording from the radio
To stop recording:
Press the button.
Note:
If you hear a whistling noise whilst recording an AM station, move
the AM loop aerial.
! Erasing recorded tapes
1 Programme tracks (see page 15).
2 Press the button.
3 Press the button, which also engages the button.
4 Press the button again to cancel the pause mode.
5 Press the ( ) button to start recording.
1
Tune in to the desired station (see page 16).
2
Load a cassette into the cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button.
4
Press the button, which also
engages the button.
5
Press the button again to begin recording.
1 Load the tape to be erased into the cassette compartment with
the side to be erased facing toward you.
2 Press the FUNCTION button until "TAPE" appears on the dis-
play.
When operating with the remote control, press the TAPE button.
3 Press the button, which also engages the button to begin
erasing.