Filter
Top Products
04/1/28 CD-DH790NH EN
6
System connections
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and position the
FM aerial wire in the direction where the strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for better reception.
When an external FM aerial is used, disconnect the supplied FM aerial
wire.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM and GND terminals. Position the
AM loop aerial for optimum reception. Place the AM loop aerial on a shelf,
etc., or attach it to a stand or a wall with screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause noise
pickup. Place the aerial away from the unit for better reception.
●
The first time the unit is plugged in, the unit will enter the
demonstration mode. You will see words scroll.
●
To cancel the demonstration mode, press the DEMO button (remote
control) during power stand-by mode. The unit will enter the low
power consumption mode.
●
To return to the demonstration mode, press the DEMO button again.
The iPod with photo and video can be viewed by connecting to a TV/
monitor.
If the TV/monitor has a video input, connect it to the VIDEO OUT socket
on the rear of the unit.
Note:
Please make sure to set iPod unit to either NTSC or PAL to match your
TV signal. Please visit Apple’s homepage for further information.
After checking all the connections have been made correctly, plug the AC
power lead of this unit into the wall socket If you plug in the unit first, the
unit will enter the stand-by mode.
Note:
Unplug the AC power lead from the wall socket if the unit will not be in use
for a prolonged period of time.
Make sure to unplug the AC power lead before making any connections.
Right speaker
FM aerial
(not supplied)
(not supplied)
screws
wall
< Attaching to the wall >
< Assembling >
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)
Installing the AM loop
aerial
Video cable
Black
Red
Left
speaker
TV
AM loop aerial
To video input
socket
■
Aerial connection
■
Speaker connection
●
Connect the black wire to the minus
(–) terminal, and the red wire to the
plus (+) terminal.
●
Use speakers with an impedance of 4
ohms or more, as lower impedance
speakers can damage the unit.
●
Do not mistake the right and the left
channels. The right speaker is the one
on the right side when you face the
unit.
●
Do not let the bare speaker wires
touch each other.
Incorrect
●
Do not allow any objects to fall into or to be placed in the bass reflex
ducts.
●
Do not stand or sit on the speakers. You may be injured.
■
Demonstration mode
■
Connecting iPod to a TV
■
AC power connection