Filter
Top Products
Using the transmitter
17
The first unused frequency preset is
transferred from the receiver to the
transmitter.
When the transfer is completed, the
display panel of the transmitter displays
the numbers of the transferred
frequency bank and channel.
Please note that the transmitter does not
automatically store the frequency bank
and channel setting.
The current frequency bank and channel
setting as well as the parameters
adjusted via the “Sync Settings” menu
item are transferred from the transmitter
to the receiver.
When the transfer is completed, “ ”
appears on the display panel of the
transmitter. The transmitter then
switches back to the standard display.
The transferred parameters are
automatically adjusted and stored by the
receiver. The transmission link between
transmitter and receiver is now
established.
̈ Place the infra-red interface of the
diversity receiver in front of the infra-red
interfaces of the remaining transmitters,
one after the other.
In each case, the next unused frequency
preset is transferred from the receiver to
the transmitter.
–
Either:
̈ Store the frequency bank and channel
setting by pressing the jog dial on your
transmitters.
The RF signal is activated. You can carry
out the Sync function (see right-hand
column) at a later time to establish a
transmission link between transmitters
and receivers.
–
Or:
̈ Immediately synchronize your receivers
with your transmitters by carrying out
the Sync function (see right-hand
column).
The icon in the left lower corner of
the transmitter display indicates that the
Sync function can be carried out. The
transmission link between transmitters
and receivers is established.
–
– To cancel the transfer:
̈ Press the STANDBY button on the
transmitter.
“ ” appears on the display panel of the
transmitter. “ ” also appears if no
suitable receiver was found.
Easy Setup Sync Sync