Filter
Top Products
Using the transmitter
13
̈ Pass the mains cable through the cable grip µ.
̈ Connect the mains cable to the mains socket ¾.
̈ Plug the mains plug into the wall socket.
Using the transmitter
To establish a transmission link, proceed as follows:
1. Switch the transmitter on (see next section).
2. Switch the
EK 2000 IEM
receiver on (see the instruction manual of the receiver).
The transmission link is established.
If you cannot establish a transmission link between the transmitter and the EK 2000 IEM
receiver, read the chapter “Synchronizing the transmitter with the EK 2000 IEM receiver” on
page 30.
Switching the transmitter on/off
To switch the transmitter on (online operation):
To switch the transmitter on and to deactivate the RF signal on switch-on (offline operation):
To activate the RF signal:
50/60Hz 0.2 A ETHERNET RJ-45
B
100 - 240V
¾
µ
It is vital to observe the notes on frequency selection on page 30.
0**
º
̈ Briefly press the STANDBY button º.
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon
ቦ
is displayed
.
̈ Keep the STANDBY button º pressed until “RF Mute On?” appears on the display
panel.
̈ Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit an
RF signal. The transmission icon
ቦ
is not displayed. In addition, the display
backlighting changes from orange to red and “RF Mute” flashes in alternation
with the standard display.
Use this function to prepare a transmitter for use during live operation without
causing interference to existing transmission links.
̈ Press the STANDBY button º.
“RF Mute Off?” appears on the display panel.
Standard -18dB
MHz
PEAK
-10
0
-20
-30
-40
PEAK
-10
0
-20
-30
-40
AF II
AF I
**2000**
552.300
B.Ch: 5.14
EQ
ቦ